E
PT043328 Issue 3 October 2021 35
How to Prepare the i-Pulse Print Head (M1630 Jet eco Only)
Do this procedure when preparing the printer for the first time.
(1) Remove the print head cover.
(2) Remove the silicone tube cap over the gutter. Check the print head is clean and dry.
(3) Replace the print head cover.
(4) Fit the print head into a wash station, or place a beaker made of a conducting
material and connected to earth (ground) underneath the print head.
WARNING: Risk of personal injury.
Only a trained person may install the printer. For full installation
instructions, refer to the product manual.
To Next Page
Loading...