2 sec
and
2 sec
or
2 sec
6
USING BLUETOOTH
Adding your telephone and deleting other
stored telephones
Press and hold the trim button for 2 seconds until
the blue LEDs start flashing.
Follow the instructions in your telephone handbook
to add a new Bluetooth unit to your telephone.
Select Konftel 60W in the list of units detected.
Enter the password 0000.
If the pairing was successful, a short audible signal
will be heard and the LEDs will stop flashing.
Removing all pairing information from
Konftel 60W
Press and hold the – and + buttons at the same
time for 2 seconds until you hear a short sound
signal.
Adjusting the microphone sensivity
The microphone volume can be adjusted during a
call, but to avoid disturbing the call, it may be best
to adjust it during a test call after the telephone has
been paired. The volume can be adjusted in 5 steps.
Please note that different telephones may have differ-
ent volumes and the microphone volume on Konftel
60W may need to be adjusted if you connect a differ-
ent make of telephone.
Press and hold the mute button for 2 seconds
until the LEDs start to flash and you hear a tone.
Increase the microphone volume using the + but-
ton and reduce it using –.
Adjust the microphone volume one step at a time until
you can hear well at the other end. Please note that
too high a volume may cause echoes and feedback.
To Next Page
Loading...
