Installation
20221016C 33
4 INSTALLATION
4.1 General
This section provides detailed information required to properly
install AP51 Remote Control. To install a complete AP50
Autopilot system, refer to the AP50 Instruction Manual.
4.2 Unpacking and Handling
Care should be taken when unpacking and handling the
equipment. A visual inspection should be made to ensure that
the equipment has not been damaged during shipment and that
all parts are present according to the packing list.
4.3 Determine system configuration
As many of the units are communicating on a common network
(Robnet), with identical connectors, the installation is
simplified. Mount the units within the standard cable length
supplied with each unit, if possible (refer to Technical
Specifications, page 31). Robnet Extension Cable (10 m) is
available from your Simrad distributor. Refer to the Spare Parts
List on page 41 for part numbers.
To Next Page