Issue 1.0 04/01/00
CONTENTS
1 INTRODUCTION
1.1 Electronics PCBs
1.2 Mechanical Components
2 CALIBRATION
3 ASSEMBLYINSTRUCTIONS
3.1 Wheelpilot WP10
3.2 Wheelpilot WP30
4 MECHANICALASSEMBLYDRAWINGS
4.1 General Assembly : WP10(E03515)
4.2 Clutch Plate Assembly (E03047)
4.3 Rear Plate Assembly (E03018)
4.4 Clutch Handle Assembly (E03045)
4.5 Drive Ring Assembly (E03046)
4.6 Gearbox Assembly (E03050)
4.7 PCB Case Assembly (E03053)
4.8 Gearbox and Ring Assembly (E03086)
4.9 Gearbox Ring / PCB Pod Assembly (E03057)
4.10General Assembly : WP30 (E03516)
4.11PCB Case Assembly : WP30 (E03054)
5 CIRCUITDESCRIPTIONS
5.1 Wheelpilot WP10 PCB
5.2 Wheelpilot WP30 PCB
5.3 Hall Effect PCB
6 CIRCUITDIAGRAMS
6.1 Circuit Schematics
6.2 Component Lists and Layouts
7 PROGRAMMING AND CONFIGURATION
8 FAULTFINDING
8.1 Common User Faults
8.2 Common Technical Faults
9 SPARE PARTS DETAIL
10 TECHNICALNOTES
Simrad Navico Ltd
Star Lane, Margate, Kent CT9 4NP, UK
Telephone +44 (0) 1843 290290
Facsimile +44 (0) 1843 290471
E-Mail : sales@simrad-navico.co.uk
©2000 Simrad Navico Ltd
The technical data, information and illustrations contained in this publication were to the best of our knowledge correct at the time of going to print. We reserve the right to
change specifications, equipment, installation and maintenance instructions without notice as part of our policy of continuous development and improvement.
No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, electronic or otherwise without prior permission from Simrad Navico Ltd.
No liability can be accepted for any inaccuracies or omissions in the publication, although every care has been taken to make it as complete and accurate as possible.
To Next Page
Loading...
