|
User’s Manual 45
08 CLOSED NETWORK
This function allows you to program your fax machine to
refuse to communicate with locations whose telephone
numbers have not been programmed into your One Touch
keys or Auto Dial locations. Using this function, you can
set up a closed network of fax machines. Refer to the
“Security, Rejecting Unsolicited (Junk) Fax Messages”
section of this user's manual. If you do not want your fax
machine to transmit faxes to or receive faxes from
locations outside your network, select T/R. If you only
want your fax machine to refuse to receive faxes from
outside your network, select RX.
Available settings are OFF (default), T/R, and RX.
09 TX MODE DEFAULT
Your fax machine is set for the STD (standard) resolution
setting and the NORMAL contrast setting. If you
consistently send faxes that require some other
combination of transmission modes, use this function
setting to change the default modes. While you are
programming, the new default combinations appear on the
lights above the Yes § and the No © keys. The default is
STD/NORMAL.
10 T/F TIMER PROG.
When set to the telephone/fax answering mode, your fax
machine automatically distinguishes between incoming
voice and fax calls. If the incoming call is a voice call, the
fax machine rings to tell you to pick up the handset. If you
do not answer, the fax machine automatically switches
back to fax mode to allow the calling party to send a fax.
The T/F TIMER function controls how long it waits before
switching back to fax mode.
Available settings are 20 SECONDS or 35 SECONDS
(default).
11 RING RESPONSE
This function controls how long your fax machine waits
before answering an incoming telephone call. The
available settings are 1 RING (default), 5 SECONDS, 10
SECONDS, 15 SECONDS, or 20 SECONDS.
!
At the default 1-ring setting, your fax machine answers
calls immediately, and you will not hear any ring. If you
need to hear the ring, change to one of the other
settings.
To Next Page
Loading...
