Basic copy operations
2
C451 2-79
2.12 Selecting Finishing settings
Various settings can be selected for sorting and finishing copies fed into the
copy output tray.
!
Detail
When loading the original into the ADF, copies will be produced accord-
ing to the specified finishing method after every page of the original has
been scanned, regardless of whether [Sort] or [Group] is selected as the
finishing type.
When placing the original on the original glass, copies are produced as fol-
lows according to whether [Sort] or [Group] is selected as the finishing type.
<If [Sort] is specified>
After all pages of the original have been scanned, copies will be produced so
that one copy of every page will be bundled together as one copy. For details
on placing the original, refer to “Scanning a multi-page document from the
original glass” on page 2-17.
<If [Group] is specified>
Each time one page of the original is scanned, the specified number of cop-
ies will be produced for that page.
2
Note
As the factory default, “Group” is selected.
!
Detail
If no finisher or separator is installed and all of the following conditions
are met, printed copies are fed out and sorted in an alternating crisscross
pattern.
A4- or B5-size paper is used.
Paper of the same size and type is loaded with the w orientation in one
paper tray and with the v orientation in another tray.
The “Auto” Paper setting is selected.
The “Auto” Paper setting is not selected when the “Mixed Original” set-
ting is selected.
To Next Page
Loading...
Need help?
General
