bizhub C759/C659, AccurioPrint C759 5-21
5.3 Fax
5
Frequently Asked Questions Chapter 5
4 Select a number, then select [New].
5 Enter the sender name, then tap [OK].
6 Repeat Steps 4 and 5 to complete entry of all sender names.
% You can register up to 20 sender names.
% To edit a registered sender name, select a sender name and tap [Edit], change the sender name and
tap [OK].
% To delete a registered sender name, select the sender name and tap [Delete], select [Yes], then tap
[OK].
% To set the default sender name, select a sender name and tap [Set as Default].
- If [Administrator Settings] - [Fax Settings] - [TX/RX Settings] - [Individual Sender Line Setup] is set to
[ON] while multiple lines are used, the default sender name can be specified for each line.
How to set: Selecting a sender name upon fax transmission
1 Load the original.
2 Tap [Scan/Fax] and select a destination.
3 Tap [Application] and select [Fax Header Settings].
4 Select a sender name to print on the fax and tap [OK].
5 Press the Start key to start fax transmission.
To Next Page
Loading...
Need help?
General
