Konica Minolta CM-700d - Setting the Date and Time

E-67
Other Settings
3
-CNKDTKGTWPI
ޓ-CNKDTKGTWPI
ޓޓޓ
ޓ9GKUU-CNKDTޓޓ
ޓޓޓ
ޓޓޓޓޓޓ






2TQDG

$G\WI
Press the [SAVE/SEL] button.
The <Calibration> screen is displayed in the selected
language.
* The figure shows an example when German (Deutsch) is
selected.
Setting the Date and Time
The CM-700d/600d has a built-in clock to record the date and time of measurement. Since the date and
time have been set at the factory, you do not need to change them under normal conditions. If necessary,
you can change the date and time settings.
[Setting Procedure]
1
1RVKQP
%QPF1((






5CORNG

5GNGEV 6CTIGV
ޓ/GCU%QPF
ޓ6QNGTCPEG&GH
ޓ%QOOWPKECVKQP
ޓ5GVVKPIU
ޓ+PUVTWOGPV
ޓ&KUR%QPF
Hold down the [MENU] button and press the
button of the cross key.
The <Option> screen is displayed.
2
1RVKQP
%QPF1((






5CORNG

5GNGEV 6CTIGV
ޓ/GCU%QPF
ޓ6QNGTCPEG&GH
ޓ%QOOWPKECVKQP
ޓ5GVVKPIU
ޓ+PUVTWOGPV
ޓ&KUR%QPF
Use the button of the cross key to move the
cursor to “Settings” and then press the
[SAVE/SEL] button.
The <Settings> screen is displayed.
3
1RVKQP
㩄㩧㩍㩨㨲㩆㨸㩧1((






 5GNGEV $CEM
ޓⷰኤ᧦ઙ
ޓ㒢⇇୯
ޓᄖㇱធ⛯
ޓ⸳ቯ
ޓᧄ૕ᖱႎ
ޓ󰶚ቯ᧦ઙ
1R
V
K
QP
㩄
㩧㩍㩨㨲㩆㨸㩧1((
ⷰኤ᧦ઙ
㒢⇇୯
ᄖㇱធ⛯
⸳ቯ
ᧄ૕ᖱႎ
󰶚ቯ᧦ઙ
5GVVKPIU
ޓ.QY2QYGT

ޜ
ޓ&CVG6KOG

ޓ
ޓ

Use the button of the cross key to move the
cursor to “Date&Time” and then press the
[SAVE/SEL] button.
The <Date&Time> screen is displayed.