84 ADVANCED PLAYBACK
VIEWING IMAGES ON A TELEVISION
It is possible to view camera images on your television. The camera has a video-out
terminal to make the connection using the supplied AV cable. The camera is compatible
with the NTSC and PAL standards. The video-output setting can be checked and set in
section 4 of the setup menu (p. 86).
1.Turn off the television and the camera.
2.Insert the small plug of the AV cable into the camera’s
AV-out terminal. The arrow on the plug should face the
back of the camera.
3.Plug the other end of the AV cable into the video and
audio input terminals on the television. The yellow
plug is for the video output. The white plug is for the
monaural audio output.
4.Turn the television on.
5.Change the television to the video channel.
6.Turn the camera’s mode dial to the playback position
and turn on the camera. The camera’s monitors will
not activate when the camera is attached to a
television. The playback-mode display will be visible
on the television screen.
7.View images as described in the playback section.
To Next Page
Loading...
Need help?
General
