88 SETUP MENU
Monitor brightness can be adjusted in 11 levels.
Brightness can be set individually for viewfinder
and direct viewing in the recording mode. Turn the
mode switch to the appropriate position before
opening the brightness option in section 1 of the
setup menu (p. 86). Also see page 28.
Use the left/right keys of the controller to adjust
brightness, the monitor image changes
accordingly. Press the central button of the
controller to set the level.
AUTO POWER SAVE
To conserve battery power, the camera will shut down if no operation is made within a
certain period. The length of the auto-power-save period can be changed to 1, 3, 5, or 10
minutes. When the camera is connected to a computer, the auto-power-save period is
fixed at ten minutes. Auto power save is set in section 1 of the setup menu (p. 86). LCD
monitor turns off after 1 minute regardless of the setup menu setting.
An image can be displayed on the monitor after it is captured.
When used with the continuous-advance, progressive-
capture, or bracketing drive modes (p. 46), the images in the
series are played back in a six-frame index display. Instant
playback is activated section 1 of the setup menu (p. 86). A
playback period of two or ten seconds can be selected. To
cancel the playback and save the image before the end of
the playback period, press the shutter-release button
partway down.
INSTANT PLAYBACK
Set LCD brightness
:adjust
:enter
Low High
LCD MONITOR BRIGHTNESS
To Next Page
Loading...
Need help?
General
