E-5
b) Connect the sensor unit’s connector to the con-
nector described in step a).
c) Route the harness through the wire saddles A,
B, and the edge cover.
Note:
Position the connector under the wire saddle A as
shown in the illustration.
<C368/C308>
a) If present, disconnect the relay connector from
the sensor unit connector.
b) Connect the sensor unit connector to the con-
nector as shown in the illustration.
c) Route the sensor unit harness through the wire
saddle and the edge cover.
(18) Reattach the cover removed in step (12) to the
main unit. (One screw removed in step (12))
Connector
Connector
Wire saddle B
Wire saddle A
Edge cover
Edge cover
Wire saddle
To Next Page
Loading...
