E-6
(19) Install the supplied upper tray into the main unit
by fitting the tab into the hole.
Note:
Fit the two protrusions on the upper tray into the
notch on the cover shown in step (18) and into the
depression on the main unit’s surface as shown in
the illustration.
(20) Secure the upper tray with three supplied
screws B.
(21) Reattach the cover removed in step (10). (Two
screws removed in step (10))
(22) Attach the job separator by fitting the three tabs
into the holes.
(23) Secure the job separator with two supplied
screws C.
(24) Remove the cover shown in the illustration from
the back of the main unit. (One screw)
Protrusion
Notch
Protrusion
Tab
Depression
To Next Page
Loading...
