E-7
(25) Plug in the two connectors of the job separator.
Fit the head of the cable tie into the mounting
hole on the main unit.
(26) Reattach the cover removed in step (24). (One
screw)
Note:
• Be careful not to pinch the harness.
• Insert two tabs A into the holes on the main unit
cover first. Then fit two tabs B into the holes.
* The installation procedure for models C554e/
C454e/C364e/C284e/C224e/C554/C454/C364/
C284/C224/C368/C308/554e/454e/364e/284e/
224e is complete.
<367/287/227>
(1) Turn OFF the power switch and unplug the
power cord from the power outlet.
(2) Remove protective tape and protective materials
and take out accessory parts.
(3) Remove the output tray from the main unit.
Connector
Cable tie
Tab B
Tab A
To Next Page
Loading...
