14
E
GETTING STARTED
You can use either 2 AA size batteries (Alkaline, Ni-MH) or a specified AC power
adapter as the power supply for the camera. Battery power is convenient for re-
cording images or video clips while AC adapter power is recommended for trans-
ferring images to your computer.
Installing the batteries
1. Make sure the camera is turned off.
2. Slide the battery/SD card cover in the direc-
tion of the OPEN arrow.
3. Insert the batteries according to the correct
polarity marks (+ or -).
4. Close the battery/SD card cover firmly.
NOTE
• A CR-V3 Lithium battery pack can also be used as the power supply.
• If you won’t be using the batteries for an extended period of time, then remove them from the
camera to prevent leaks or corrosion.
• Never use manganese batteries.
• Never use different types of batteries together or mix old and new batteries.
• Low temperatures can shorten the battery life and reduce the performance. Avoid using them in
extremely cold environments.
Using the AC power adapter (optional)
1. Make sure the camera is turned off.
2. Open the DC IN jack cover and connect one
end of the AC power adapter to the DC IN
jack on the camera.
3. Connect the other end to an electrical outlet.
• Make sure that you use only the specified AC power adapter (2.5A/3.3V:optional) for the camera.
Otherwise, it may cause damages to the camera, which is not covered under the warranty.
• To prevent the camera unexpectedly turning off during the transfer of images to the computer if
the batteries become exhausted, we recommend that you use the AC power adapter as a power
supply.
NOTE
To Next Page
Loading...
