12 OPERATION MANUAL
OPERATING PROCEDURES
● The READY lamp will go out.
● As soon as film insertion is completed, the ready
signal (beep) will sound and the READY lamp will
go on again.
t After the beep stops, insert the next sheet of film.
If you insert the next sheet of film before the
beep stops, the two sheets will go through the
processor stacked one on top of the other and
the film will not be processed.
Don't fail to line the film up with the guides, or the
sheets of film may be jammed at the gears,
causing the scratch on the film and the damages
against gears and drive motor.
y After all the film is inserted, close the feed tray
cover.
To speed up processing of smaller size film
(8"x10" or less), you can feed two sheets in at
the same time: one sheet along the left-hand
guide, and the other along the right-hand guide
(See diagram below). Just make sure that they
do not overlap.
NOTE:
CAUTION:
HINT:
To Next Page
