INSTALLATION PRECAUTIONS
1. Prepare a power supply outlet of AC 115/120V, more than 15A exclusively for SRX-101A. An insufficient power supply outlet
may cause overheating and/or smoke emission in the field.
2. Lay the power cord out so that it will not be tripped over and will not hit other pieces of equipment. Plugs and cords bent or
frayed from constant abrasion and/or trampling may cause damage due to overheating and/or smoke emission in the
machinery.
3. Use only direct wall/floor socket connections to power the SRX-101A. Hooking the processor into desk-top sockets, double
connectors, or multi-socketed connectors may cause damage due to overheating and/or smoke emission in the machinery.
4. If an extension cord is required, use only cords that have been approved according to local public utility standards. Improper
extension cords may cause damage due to overheating and/or smoke emission in the machinery.
5. Ground the SRX-101A to prevent electrocution accidents. Avoid the possibility of electrocution or even explosions by not
grounding the processor to any of the following places:
1) Gas pipes
2) Lightning rods
3) Ground lines specially designed for telephones
4) Any water line or attachment
6. Keep all flammable and combustible materials away from the SRX-101A.
7. Keep direct forced air from heating and cooling equipment away from the SRX-101A.
8. Install the SRX-101A in a space that is well ventilated.
9. Use the SRX-101A on a perfectly flat, sturdy surface with a minimum of vibration.
10. Install the SRX-101A in a position accessible for easy operation, checking and maintenance.
11. Carry the main body of the SRX-101A on a conventional hand carrier by two persons.
2 OPERATION MANUAL
NORMAL HANDLING PRECAUTIONS
1. There are dangerous high voltage areas inside the processor. Do not try to remove the cover with a screwdriver or any other
tool while the processor is ON.
2. Keep foreign objects from falling into the processing tanks.
3. If you detect any unusual noise, odor or smoke coming from the processor, discontinue use immediately, switch the film
processor’s power switch OFF, and disconnect the power cord from the wall socket. Then call your nearest authorized
KONICA dealer.
4. Do not try to take apart, modify, or adjust the processor in any way not specified in this manual. Use only KONICA
recommended parts and do not try to use the processor for any purpose other than specified in this manual.
5. Periodically do the following check procedures 1) Is the power cord to the processor overheating?
2) Are there any cuts or fraying in the plug socket or power cord?
3) Make sure that the ground wire is properly connected.
6. If you do find any problems during these checks, discontinue operation and contact your nearest authorized KONICA dealer.
7. The SRX-101A, chemical solutions are classified in industrial waste category. Entrust their disposal to an authorized disposal
expert.
8. The processing solutions and starter are dangerous to eyes, skin and clothing. In case of eye injury, wash your eyes
thoroughly with cold, running water, then consult a doctor immediately. In the case of contact with skin or clothing, wash the
affected areas immediately with water.
9. Use chemicals correctly by strictly following the manufacturer's instructions.
10. Turn the power breaker OFF whenever you clean or check the racks in the processing tanks.
11. Don't peel off the CAUTION LABELS.
PRECAUTIONS
To Next Page
Loading...