KW710
Attention: If “Replace” resulted from IN-VEHICLE mode, it might be the
reason that vehicle cable is not well connected with the battery,Ensure to
cut off the cable and retest the battery under OUT-OF-VEHICLE before
making a decision to replace battery.
Cranking Test
Important note: Before starting the test, check the drive belt of the generator.
If the belt is shiny or worn, or lacks proper tightness, the machine will not
reach the speed level required for detection.
1.When the battery test in the car is completed, the battery test results and
prompts will be displayed alternately. Press Enter to test and start the
system.
2.Press the enter key to do cranking system test.
3. The tester will prompt to start the engine.
4. The KW710 tester will displays the test results : the max cranking voltage,
the min the cranking voltage, and the cranking time in milliseconds, cranking
lower / higher etc.
TIME: 7554ms
MAX:9.84V
MIN:8.47V
CRANKING LOW
To Next Page
