KW710
Noted : If test on the vehicle, please make sure to disconnect all loads, and
don't out the key in the ignition position and must close the door . Connect
the red clip to the positive (+) terminal of the battery and the black clip to the
negative (-) terminal. After connecting, shake the clip back and forth to make
the connection firm. Before testing the battery, two clips are required to
connect the terminals firmly.The best test location is the connection port of
the battery. If the battery cannot be connected from the wiring port, you can
try to test on the jumper port, but the measured data may be lower than the
actual value.
Menu Selection
Motorcycle menu
After entering motorcycle menu ,
select “ Battery Rating“ The screen
will display
the test result ,
Press the up and down keys to switch
between SOH and SOC
SOC:state of charge
SOH :state of health
Batterytest result includes 5 types as following:
( Good Battery /
Good, Recharge /
Replace / Bad cell, Replace /
Charge, Retest )
To Next Page
Loading...
