Increase RPM to 2500 r/min and keep it
5 seconds, Press ENTER to continue
Generator output detected.
√ Check the belt to ensure that the generator rotates with the
engine running. Replace the broken or slipped belt and retest.
Check all connections on the generator. Especially the connector
connected to the battery. If the connector is loose or severely
corroded, clean or replace the wire and retest.
√ If the belt and joint are in good condition, replace the
generator. (An external voltage regulator for old vehicles may
only need to be replaced.)
The generator does not provide enough current to load the circuit
of the system, also it does not have enough current to charge the
battery.
√ Check the belt to ensure that the generator drives the engine to
To Next Page
