1. Washing solution
Use a scale remover that is not harmful to human
s by diluting with water, and use a larger
amount if necessary.
It is important to use the diluted cleaning solution immediately for safety and maximum
effect.
2. Washing procedure
1) Shut off the water supply by locking the water line valve of the ice maker.
2) Switch the ICE MAKING-OFF-WASH switch to the "WASH" position.
3) The water in the water tank is drained through the
evaporator cylinder and washing begins
(max. 5 minutes).
4) Turn the ICE MAKING-OFF-WASH switch to "OFF" position.
5) Remove all ice from the ice maker and reservoir.
6) Pour the wash solution into the wash solution inlet until the evaporator assembly and the
water tank are full (overflows into the drain box)
7) Leave the ice maker for 10 minutes before starting operation. If the water supply hose is
clogged, remove it before operation.
8) As described below, disassemble and clean the water level sensor (high and low) if it is in
bad condition.
If not, proceed to step 9.
Ⓐ Remove the water level sensor from the water tank cover.
Ⓑ C
lean the level sensor with washing solution.
Ⓒ Wash the water level sensor thoroughly with clean water.
Ⓓ Fix the level sensor to the correct position.
9) Switch the ICE MAKING-OFF-WASH switch to the " ICE MAKING " position to start the ice
maker. Keep it
running until ice making stops. (※ Water supply valve should be closed so that
water is not supplied.)
10) Switch the front ICE MAKING-OFF-WASH switch to the "WASH" position, and drain
the remaining water in the water tank and evaporator cylinders for 5 minutes.
24
After cleaning and disinfection, do not use ice made from cleaning agent and disinfectant. Be
careful that no disinfectant remains in the ice maker or reservoir.
● Do not use ammonia-type detergents to prevent personal injury or damage to the ice
maker.
● Disinfection and cleaning should be handled according to the instructions provided.
● Always wear protective eyewear and waterproof gloves to prevent skin or eye contact
with water and disinfectant.
Warning
※ The ice maker should be cleaned and disinfected at least twice a year. More frequent
cleaning and disinfection may be required.
◆ Please observe the following points.
How to clean and disinfect
11) Switch the ICE MAKING-OFF-WASH switch to the "OFF" position.
12) Open the water supply valve of the ice maker, and switch the ICE MAKING-OFF-WASH
switch to the " ICE MAKING " position so that water can be supplied to the water tank.
13) When the geared motor is activated, switch the ICE MAKING-OFF-WASH switch to the
"WASH" position and drain the water (5 minutes).
14) Turn OFF the power switch and disconnect the power cord from the outlet.
To Next Page
Loading...