WATER button lamp
- Press the button to light up. If you put the cup on the ice exit, you can discharge the
water for the time as set in F1.
ICE & WATER button lamp
- Press the button to light up. If you put the cup on the ice exit, you can simultaneously
discharge ice and water for the time as set in F1.
ERROR Signals
ICE, WATER-ICE, & WATER button will flicker in sequence and will disappear when restarting
once the ERROR has been rectified.
Service cycle setting notification (parts check / replacement cycle notification)
- If the motor has been running for more than 10,000 hours, the corresponding lamp
blinks for 5 seconds in the initial stage of the ice making.
- If the motor has been running for more than 11,000 hours, all the buttons will blink
for 5 seconds in a 1 hour cycle.
※ If all the buttons are flashing, it is a signal to check / replace regular replacement
parts and you should contact the customer service center.
Failure to check / replace parts may result in higher repair costs.
Function Button Description (FND Display
Window)
F1 (Maximum Discharge Time)
① SOLENOID Maximum operating time adjustment function.
② 3
rd
, 4
th
digits: 20 seconds (5 seconds ~ 30 seconds, Set Unit of one second)
F2 (Complete removal of ice in the reservoir)
① This function can be entered in "OFF" state of ICE MAKING-OFF-WASH switch.
② Press two buttons (WATER, ICE) simultaneously for 3 seconds and Button LED
lights up.
12
To Next Page
Loading...