11
Using the Control
For your convenience, your KoolR control is preset at the factory. When you first install your
KoolR, make sure that the control is still preset at 57 degrees.
Adjusting Controls – follow steps on the back of the attached template
The mid-setting indicated in the previous section should be correct for normal usage.
If you need to adjust the temperature, wait at least 24 hours between adjustments and then
recheck the temperature. To make the cellar colder, adjust the control to the next lower setting.
To make the KoolR less cold, adjust the control to the next higher setting.
Temperature Display
The controller displays the current temperatures (Fahrenheit or Celsius) of the cellar if not within
3 degrees of the set point. To adjust the temperature settings, see “Adjusting Controls” earlier in
this section.
Wine Racks
Never install racking close to any side or under the cooling unit, to keep the air flow unrestricted.
Failure to do so will lead to poor performance.
Stocking the Cold Room
There is a normal temperature gradient within the cellar. In the vicinity of the cooling unit and in
the direct air flow temperatures will be slightly lower. Stock the cellar or pantry accordingly.
Note: Only air temperature varies up to 6 degrees during the ON/OFF cycles, but liquid
temperatures are not affected by this fluctuation.
Lighting the Cold Room
NOTE: Leaving the light on for an extended period of time will increase the temperature of the
room.
To Next Page
Loading...