7
Before you install your KoolR in its final location, it is important to make sure you have the proper
electrical outlet.
Outlet (on cool side) power must be a dedicated separately fused grounded 15-Amp 115 Volt
line within reach of supplied power cord (Europe; 10-Amp 220 Volt). Line must not be shared. Do
not use extension cords.
Electronics must be protected against sudden power surges. Use a quality surge protector.
Recommended grounding method:
A 115 Volt, 60 Hz., AC only, 15 fused, grounded electrical supply is required. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or maintenance, unplug the KoolR or
disconnect the power.
Do not use if power cord is damaged; it must be replaced by the manufacturer or by a qualified
person to avoid a hazard. Plug must remain accessible after installation.
Test line voltage before operating, and do not use if line voltage is less than 105V.
Unpack the KoolR
Excessive Weight Hazard
Use two or more people to move and install your KoolR.
Failure to do so can result in back or other injury.
Remove the Packaging
■ Open box and read the instructions.
■ Do not use sharp instruments.
■ Dispose of/recycle all packaging materials.
After you remove all of the packaging materials, clean your KoolR , small pieces of packing
material might need to be vacuumed out.
To Next Page
Loading...