8
Inspect for shipping damages
Report any major damage to: www.vintagekeeper.com
Cosmetic damages are not covered by the warranty.
Test the unit before installation.
Rest the unit on a horizontal surface for at least two hours for the compressor oil to drain to the
bottom of the compressor before power –on.
Before installation run a table top test for at least 10 minutes. Monitor the unit during the test run!
The display should light up, the air flow has to start within a minute and the compressor will follow
in the next minute. The “warm” side will exhaust warm air and the “cold” side will exhaust cool air.
Record your serial number located on the side of the unit.
Prepare your room
Build the wine cellar or pantry according to the described requirements: Insulated walls and
floor, dedicated power, insulated sealed door.
Prepare wall cut out for KoolR
Follow step by step guide on attached template.
KoolR installation
To Next Page
Loading...