6
TEMPERATURES:
Select a suitable area, sized to model’s cooling capacity, where ambient temperature will not exceed the
desired storage temperature by more than 25ºF (14ºC). The temperature of the air where the unit vents
its warm air must be at least 65ºF and never exceed 80ºF with 70% R.H.
Lower set temperature from default 57ºF (14ºC), only if ambient condition allows.
Set temperature range: 53ºF - 64ºF (12ºC - 18ºC)
INSULATION:
Install unit where ALL surfaces (walls, floor and ceiling) are insulated to R-20 and protected by vapor
barrier on both sides. Un-insulated concrete floors will radiate heat and humidity during summer months,
forcing the unit to work inefficiently. All floors must be INSULATED! Use an insulated door with weather
seal.
Electrical Requirements
Installation must comply with local electrical codes and regulations.
This unit must be installed in accordance with national wiring regulations.
To Next Page
Loading...