42
Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements
carried out.
Preparation of the location and electrical, tap water and waste water installations at the place of
installation is under customer’s responsibility. Make sure that the water inlet and discharge hoses
as well as the power cable are not folded, pinched or crushed while pushing the product into its
place after installation or cleaning procedures.
warning: Installation and electrical connections of the product must be carried out by the
Authorized Service Agent. Manufacturer shall not be held liable for damages that may arise from
procedures carried out by unauthorized persons.
warning: Prior to installation, visually check if the product has any defects on it. If so, do
not have it installed. Damaged products cause risks for your safety.
2.1 Appropriate installation location
- Place the machine on a rigid floor. Do not place it on a long pile rug or similar surfaces.
- Place the product on a solid and flat floor that has suicient load carrying capacity!
- Do not place the product on the power cable.
- Do not install the product at places where temperature may fall below 0ºC.
- Place the product at least 1 cm away from the edges of other furniture.
2.2 Removing packaging reinforcement
Tilt the machine backward and remove the packing reinforcement by pulling the tape. Do not
perform this operation alone but with the support of at least one other person.
To Next Page
Loading...