Korenix JetNet 5010G Series User Manual

6
2.2 Wiring Power Inputs
Follow below steps to wire JetNet 5010G redundant DC power inputs.
1. Insert positive and negative wires into V+ and V- contacts respectively of the
terminal block connector
2. Tighten the wire-clamp screws to prevent DC wires from being loosened.
3. Power 1 and Power 2 support power redundancy and polarity reverse protection
functions.
4. Positive and negative power system inputs are both accepted, but Power 1 and
Power 2 must apply the same mode.
Note 1: It is a good practice to turn off input and load power, and to unplug power terminal
block before making wire connections. Otherwise, your screwdriver blade can
inadvertently short your terminal connections to the grounded enclosure.
Note 2: The range of the suitable electric wire is from 12 to 24 AWG.
Note 3: If the 2 power inputs are connected, JetNet 5010G will be powered from the
highest connected voltage. The unit will alarm for loss of power, either PWR1 or PWR2.
Note 4: To use the UL Listed LPS power supply with output Rating 12-48 Vdc or
10.5~60Vdc for 2.3 hardware version, minimum 1 A.

Korenix JetNet 5010G Series Specifications

General

Brand	Korenix
Model	JetNet 5010G Series
Category	Network Router
Language	English