Korg DW-8000 - TAPE INTERFACE; Features and Functions for Control

TAPE INTERFACE
The DW-8000 is equipped with a tape • interface that lets you SAVE all sound data stored in memory
on cassette tape. Later you can LOAD the data from the tape back into the DW-8000's internal
memory. A wide variety of sound data can be stored on cassette tape. The LOAD operation is so fast
(a little more than 10 seconds) that you can even change your programs during a performance.
l .Features and Functions for Control_
■ Front Panel
s
_________ ...!
•
. . . . ' ·•
PARAt.ET£R NO
VALUE
S 6 7 8 WRITE
g;m~
3
4
C
• • I • ,
I.SAVE key
Press this key to write OW-8000 program memory
contents
to your connected tape recorder.
2.LOAD key
Press this button to read data from your tape recorder
while playing back a tape.
3. VERIFY key
This is ,used to check recorded data {immediately
after the SAVE
or LOAD procedure) to make sure that
it has been properly performed.
4. CANCEL
If an error occurs during SAVE or LOAD operati on ,
pressing this key lets you start over again. If you
press the CANCEL key during SAVE, LOAD. or
VERIFY operation, it will immediately interrupt and
cancel
the operation.
■ Rear Panel
WRITE TAPE FROM TAPE
ENABLE DISABLE ENABLE DISABLE LOW
7
HIGH
71 71 Q.o 71
limiJ ~ Imp
l 7 l
5.DISPLAY
This gives you messages to keep you informed of
tape interlace operations and possible problems.
6. WRITE switch
This is set tQ ENABLE to enable LOAD operation.
7. TAPE switch
This switch is set to ENABLE to make tape interface
possible.
8. HIGH/LOW switch
This switch is used to make the DW-8000 match the
output level
of the connected tape recorder during
VERIFY or LOAD operation.
43