Korg DW-8000 - LOAD Procedure

TAPE INTERFACE
4.LOAD Procedure _____ _
■ This procedure is used to put recorded data back into the DW -8000's Internal memory.
1 Connect the DW-8000 rear panel FROM TAPE jack to
lhe outpu1 j ack (earphone, line out, etc.) of your
re co rd er. Set the LOW/HIGH sw itch lo match your
tape recorde
r's output signal level.
2 Se t the OW -8000 rear panel WRITE switch and TAPE
switch
to the ENABLE (ENA) position s.
3. Set the tape recorder's playback volume to the level
that pr
od uced a "Good" indication when you use the
VERIFY procedure.
If the recorder has tone control s,
set them to the center positions.
4 Rewind the tape. Begin tape playback. Stop the tape
(using the stop or pause key) when you reach t
he be-
ginning
of the leader tone.
5: Press the LOAD key.
·6 Start tape playback (press the play key
or release the
pause key). The Display will appear as shown here.
-48
WRITE
ENABLE OISABlE
7 r
Ill[]
-
E
PROGRAM NO
•
PROGRAM NO
•
PROGRAM NO
Reco,der output jack
.
AUX (l i ne ou t)
E arpllone or headphone output
TAPE
ENABLE OISABlE
, r
liJ
◄ '""'"""
•
PARAMETER t,Q
PARAMETER NO
HIGH/LOW
LOW
HIGH
PARAMETER NO VALUE
This shows the
bank number (1
- 8) if data is
1oad1n9.