Korg DW-8000 - Page 47

IL If the recorded data match the DW-8000 internal
memory data then lhe DISPLAY will give a "Good"
indication. The DISPLAY will appear as shown here if
data is successfully verified.
• ff you get an error (Err) message as shown here
Press lhe CANCEL Key, tower (or raise) lhe tape re-
corder's output volume, and repeat steps 14l - l61 .
• ff the OISPLAV does noi change after ten seconds
of tape playback
Raise the tape recorder's oulput volume level and re-
peat steps~ - IID.
a When you get a "Good" message, you can stop the
tape recorder. Make a note of the recording level.
playback level, and HIGH/LOW switch setting thal re-
sulled in the "Good" message.
Jl Set the DW-8000 rear panel TAPE switch to the DIS-
ABLE position.
•
PROGRAM NO
Ill
PROGRAM NO
Ill
. ··• . . -•
•
PROGRAM NO
TAPE
ENABLE DISA8LE
7 r
Oiil
TAPE INTERFACE
•
PARAMITTR NO
•
PARAMITTR NO
4
g
CANCEL
•
PARAMITTR NO
•
PARAMETER NO
r· •• · · ---- •--•••• •• ••• •- ••• •••---- -•- - •••• ••••••• • .. •• h · ••• •-- •-•- •-- •-••••- ••• •-•-• ••- •--- - --•---• •• •• • ••• ••• ••• • •- ••• •- •••- • ,
I Note: Vou will not get a "Good" message If the recorded data is different In any way from the data in thel
:ow-aooo·s Internal memory. If you change a single parameter value or the key assign mode and then try;
I VERIFY, you will get an error "Err" m"88ge. 1
i If you still don't get a "Good" message after trying many different output level settings on the tape recorder!
1 (and HIGH/LOW switch setting, on the D-W-8000) then your recording level may be wrong. Try saving again at a:
j different recording level.
·- - -------·-· ·-- - -----·--- --- ·- --------- --- ·- ------- --- -------------·
47