Korg DW-8000 - Page 56

MIDI
- CHANNEL
This parameter is used to select a channel for data send
and receive. T
he same channel must be spec ified for
sending
and receiving da ta . (Different channels cannot
be selected independently for send and receive.) At
power-
ON, the data send/receive channel is set for t hat
previously selected .
• ENABLE
This selects which kinds of received MIDI data the
DW -8000 will send and receive. At value 1 (NOTE
DATA), the DW-8000 sends and receiv
es only "note
data." At value 2 (All), it sends and rec ei ves all MIDI
data
spec ifi ed in the DW -8000 MIDI specifications (im-
plementati
on notes.)
For example, if you
don't want program numbers to be
changed by some external device through MIDI, then
set this value to
1.
The most recently selected ENABLE value is retained
when power is
tu rned on and off.
-OMNI
Omn i mode ON (value 1) is selected by default when the
power is turned on. When
Omn i mode is on, the DW-
8000 r
ece iv es MIDI da ta on all channels (regardless of
the parameter 84 setting). However, Omni mode can
also
be turne d on and off from the controlling (sending)
dev
ic e. When Omn i mode is off, then the DW-8000 re-
ceives MIDI
da ta sent only on the MIDI channel speci-
fied by parame t er 84.
- ARP CLOCK (Arpeggio clock)
■ Determines whe ther t he Arpeggiator is operat ed by
the DW-8000's internal clock or it is operated by the
signals, including timing clock, start,
and stop, sent
from external MIDI equipment.
Th is par.ameter is also
used
for rough adjustment of arpeggio speed.
56
VALUE
f
I
1
:o
VALUE
2
VALUE
n
u
DATA SEND/RECEIVE CHANNEL
CH
-1
1
CH-16
Kind
of Data Sent/Received
(NOTE DATA)
NOTE ON/NOTE
OFF
(ALL)
All
data
OMNI MODE
OFF
ON