Korg DW-8000 - DW-8000 Send;Receive Data

MIDI IMPLEMENTATION
~THE OW-8000 CAN SEND/RECEIVE THE FOLLOWING DATA.
111,Hi,i·I
DEVICE ID
WRITE COMPLETED
WRITE ERROR
DATA SAVE
(D ATA DUMP)
l:MiJNi,H
RECEI VE ID REQUEST
WRITE REQUEST
DATA SAVE REQUEST
DATA LOAD (DATA DUMP)
PARAMETER CHANGE
:
Id entifies the equipment. Sent upon receiving a DEVICE REQUEST.
: Sent in response to a WRITE REQUEST.
Th is indicates lhat the PRO GR AM WRITE
task h
as been successfully co mpleted.
: Sent in response to a WRITE REQUEST. This indicates th
at the synth is set to th e
WRITE DISABLE mode
so PROGRAM WRITE task cannot be completed.
: In response to a DATA SAVE REQUEST,
th is sends the data for the sound pre sently
being produced.
: A request for
th e equipment's MIDI identification number.
: A request for the DW-8000 to write data for
th e prese nt sound to program memory.
: A request for t
he DW-8000 to send data tor the present sound.
: Sound
dat a information. Sound da ta is entered via the Data Loa d.
: Used to change pa ra me ters of the current sound.
■ The DW -8000 can use the se system ex cl usive messages to communi cate with a computer equipped with a MI DI in-
terface. (A program to process t
he exclusive messages is requ ir ed.)
■ Connecting a computer
. ... ...... ·.···· --
.
MIDI
OUT
IN
Computer
Interface
MtDI
Mlll4
DW-8000
.
IN
OUT
-
Because each exclusive messa9e for the DW-8000 is spe ci fied with a c ha nne l <;le$ign ated by pa rameter 84, the corre-
sponding channel must be used for message transmission from a computer to the DW-8000. A message sent usi
ng
the incorrect channel will be ignored, regardless of OMNI mode being ON or OFF.
Th
ese channe ls are used to ettecti ve ly th at timbre control could be done independen tl y tor each DW-8000 in a system
using
tw-o or more DW-8000s.
70