Korg LP-180 - Page 9

9
8. Connecttheaachedpedalcord,observingthecorrectori-
entation,totheconnectoronthereversesideofthepedal
unit,andthenengageitwithaslotinthepedalunit.
The pedal cord can be aached to or detached from the
connector with its locking tab held down.
Locking
tab
9. Connectthepedalcordtotheconnectorsonthebot-
tomoftheLP-180.
When connecting the pedal cord, observe the correct ori-
entations of the connectors. In addition, the pedal cord
can be aached to or detached from the connector with
its locking tab held down.
Cord holder
Pedal cord
Locking tab
10.Usethecordholdernexttotheconnectortoholdthe
pedalcord.
Aer securing the cord with the cord holder, ensure that
excess pressure is not applied to the connectors.
11.ConnectthededicatedcordtotheACadapter.Then,
plugtheACadapterintotheDC12Vconnector,and
wrapthecordaroundthecordhookofthepiano.For
details,referto“1.ConnectingthePower(Figure1)”
onpage3.
12.PlacetheLP-180whereyouintendtouseit.Makesure
toplaceitinasafelocationwheretheoorisatand
stable.
When seing the digital piano in place, make sure
that the stand does not rest on the AC adapter cable
or pedal cable.
Check following assembly
□ Areanypartsleover?
If any parts are le over, carefully review the assembly
procedure to see where those parts should have been
used.
□ Makesurethatallscrewsaretight.