15
If you’re routing the M50’s audio signal to an audio track, arm the REC button on so that
you can hear/monitor the audio signal.
If you are routing the M50’s audio signal to an AUX input track, this setting is not
necessary.
Audio Track
Other host applications
Start up your host application.
Start up “M50 Plug-In Editor” as a plug-in instrument.
Create a MIDI track. Choose “M50 Plug-In Editor” as the output of that MIDI track.
To route the M50’s audio signal to your host application, create an audio track. On the
input section of that audio track, select the input that you connected the M50’s audio
signal to.
Enable the monitor function on the audio track that will be receiving the audio signal from
the M50.
Note:
The instructions given here for “Other host applications” may not necessary be appropriate
for setting-up all host applications. Please refer to the instructions for a host application that has a
similar structure to the host application you’re using, and always refer to the owner’s manual for
the specific host application that you are using.
About MIDI timing
If you experience irregularities in MIDI timing, please adjust the settings so that MIDI messages
are sent directly to the M50 rather than being routed through the M50 Plug-In Editor. In this case,
select the M50’s SOUND port as the MIDI OUT destination of the MIDI track in your host
application, so that the MIDI messages will be sent directly to the M50.
Note:
For details on how to create a MIDI track and specify the MIDI OUT destination for that
MIDI track, refer to the host application’s owner’s manual.
To Next Page
Loading...
Need help?
General
