25
Functions specific to the editor
These are functions that are not found on the M50, and are available only from the editor (M50
Editor, M50 Plug-In Editor).
Utility commands
Load
Loads editor data that was previously saved on the computer.
Save
Saves data from the editor to your computer as a file.
Note:
These functions load or save the data as dedicated files for the editor application.
Receive All
Receives all data from the M50 data into the editor.
Note:
The sequencer performance data of Sequencer mode is excepted.
Transmit All
Transmits all data in the editor to the M50 and writes it into internal memory.
Receive All Combi/Current Combi Bank
Receive All Prog/Current Prog Bank
Receive SEQ
Receive Global Data/Drum Kit/Arpeggio Pattern
Receive the corresponding data from the M50 into the editor.
Transmit All Combi/Current Combi Bank
Transmit All Prog/Current Prog Bank
Transmit SEQ
Transmit Global Data/Drum Kit/Arpeggio Pattern
Transmit the corresponding data from the editor to the M50 and writes it.
Receive Current Combi/Current Prog/1 SEQ/Current Arpeggio Pattern
Receive the respective data from the M50 into the editor.
Transmit Current Combi/Current Prog/1 SEQ/Current Arpeggio Pattern
Transmit the respective data from the editor to the M50.
Note:
These Receive and Transmit commands use KORG SysEx MIDI Dump to send or receive
data, or to synchronize the data between the M50 and the software.
Don’t touch the keyboard or the mouse of your computer while data is being sent or received.
Also, don’t touch the panel switches or the keyboard of the M50.
Import
Loads PCG data from the M50 into the editor.
PCG data from the M3 or data that was created in M3 Editor can also be converted and loaded into
the editor. (Not all data is necessarily compatible.)
To Next Page
Loading...
Need help?
General
