Korg M50 - Host Application Settings; Apple Logic Pro 8 Setup

10
Host application settings
The following material explains how to start up the M50 Plug-In Editor in your host application
and select the appropriate settings for it to operate properly. Please proceed to the specific
explanation for the system you’re using.
Apple - Logic Pro 8
1
2
Start up Logic Pro 8.
Create a Software Instrument Track, and initialize the “M50 Plug-In Editor.”
Software Instrument Track
3
To route the M50’s audio signal into Logic Pro 8, create an audio track or an audio AUX
track. On the I/O source for that track, select the audio interface input to which you’ve
connected the M50’s audio signal.
Audio Track
4
If you’re routing the M50’s audio signal to an audio track, arm the REC button so that you
can hear/monitor the audio signal.
If you are routing the M50’s audio signal to an audio AUX track, this setting is not
necessary.
Audio Track