Korg MPS-10 - Power Management; Connecting the AC Adapter; Turning the Unit On

MPS-10 - Playing the MPS-10
En-10
KIT, INST (instrument) and SAMPLE data
Aside from the sounds for the pads, each KIT stores the settings for each sound, as well as the EQ and effect set-
tings.
The sounds assigned to each pad are called “instruments” (INST).
There are more than 2,000 INST available as presets on the MPS-10. You can enjoy a wide variation of sounds just
by changing the INST assigned to each pad.
Each INST has up to two oscillators (OSC), and you can play two OSC at the same time for a single INST.
Further, each OSC contains up to eight “blocks”, and a SAMPLE is assigned to each block.
For the SAMPLEs, you can use the SAMPLE data that was recorded using the sampling functions of this unit, or
import external audio files (WAV files in 44.1 kHz/48 kHz 16-bit format or AIFF files in 44.1 kHz/48 kHz 16-bit
format) via a USB flash drive.
See the Owner’s Manual (HTML) for details on editing the KITs, INST and SAMPLEs.
KIT INST
INST
INST1
INST2
INST3
PAD1
OSC1
INST
PAD2
INST
PAD15
SAMPLE
Block1...8
OSC2
Block1...8
SAMPLE1
SAMPLE2
SAMPLE3
SAMPLE4
SAMPLE5
SAMPLE6
SAMPLE7
One block refers to one
SAMPLE
One pad refers to one
INST