Korg nanoPad2 - Troubleshooting

13
Troubleshooting
Troubleshooting
•Trigger pads do not respond to velocity
- Check the trigger pads velocity curve.
•Your application does not respond to MIDI data transmitted from the nanoPAD2
- Make sure that the MIDI channel of the data being transmitted by the nanoPAD2 matches the MIDI channel of your application.
•Your application does not respond when you use the trigger pads or X-Y pad
- Make sure that the Assign Type is set correctly.
-In order to use the nanoPAD2’s functions, you might need to adjust settings in the application that you’re using. Refer to the owner’s manual for your application, and
adjust the appropriate settings.
• Gate arpeggiator does not operate
- Make sure that the MIDI Clock setting is correct.
- Make sure that the Trigger Pad parameter Gate Arp Enable (p.7) is set correctly.