28| Interface basics
Virtual controllers
Virtual sliders
To change a virtual slider’s position, touch it and keep it held, then slide up or
down to change its position. As an alternative, touch it, then use the VALUE
control to change its position.
Virtual knobs
To change a virtual knob’s position, touch it and keep it held, then slide your
finger up (or right) to rotate it clockwise, or slide it down (or left) to rotate
the knob counter-clockwise. As an alternative, touch it, then use the VALUE
control to change its position.
Virtual drawbars
To change a virtual drawbar’s position, touch it and keep it held, then slide
it up or down to change its position. As an alternative, touch it, then use the
VALUE control to change its position.
To Next Page
Loading...
