36
Connecting and calibrating the Damper pedal
Programming the Damper pedal
4 Touch the Foot Contr. tab to select the “Foot Controllers” page.
This is the page where you can program the Assignable Pedal/Footswitch and the Damper ped-
als.
5 Touch the “Calibration” button in the Damper section, to make the “Damper & Pedal/
Footswitch Calibration” dialog box appear.
6 Fully press the Damper pedal down, and while continuing to press touch the “Push”
button to confirm the maximum value.
7 When the following dialog box appears, release the pedal.
8 Touch the “Push” button in the display to confirm the minimum value.
Check if the pedal is working properly. In case it isn’t, repeat the procedure.
9 Press the EXIT button to return to the previous operative mode.
Pa3XLe User Manual v100 (English).book Page 36 Thursday, May 29, 2014 5:42 PM
To Next Page
Loading...
