Korg SP-280 - Adjusting Front Leg Clearances to Floor; Check after Installation; Installing Optional Pedal Unit (Sold Separately)

24
6. TightenknobboltsBforthebracesattachedtothe
rearlegs.
Knob bolt B
of brace
Knob bolt A
7. Checkthesurroundingarea,andthenturnoverthe
SP-280withouthiinganything.
Adjusting front leg clearances to oor
Follow the procedure below to nely adjust the clearances
between the front legs and the oor within 3 mm.
1. Turneithertheleftorrightfrontlegcounterclock-
wise(directionofarrow1)alileatatimetoadjust
theclearancebetweenthefrontlegandtheoor.
2. Holdtheadjustedlegsoitdoesnotturn,andthen
turntheadjusteratthetopofthelegclockwise(di-
rectionofarrow2)untilitisrmlysecured.
1
2
Adjusters
Adjusters
Check after installation
• Are any parts le over?
If any parts are le over, carefully review the assembly
procedure to see where those parts should have been
used.
• Make sure that all screws are tight.
Installing optional pedal unit (sold sepa-
rately)
If you purchased pedal unit, continue by installing the
pedal unit.
Make sure that the power of the unit is turned o when
connecting the pedal unit to it.
Connectthepedalcordtotheconnectorontheundersideof
theunitandfastenitwiththecordholder
.
Be sure to connect the pedal cord with the connector in the
correct orientation.
Hold the locking tab while inserting or removing the ped-
al cord.
Cord holder
Keyboard
side
Rear
panel
side
Locking tab
Rear panel side