Korg TM-50 User Manual

10
Using the tuner
Tuning while watching the meter
(Meter mode)
1.
Connect your instrument cable or contact
mic to the TM-50’s INPUT jack.
If a device is not connected to the
INPUT jack, tuning will be performed
by the internal mic.
2.
Press the TUNER ON buon.
“
” will appear at the top
of the display and the calibration (refer-
ence pitch) will be displayed below that.
3.
To change the calibration, press the
CALIB/NOTE
p
or
q
buon.
The calibration value increases and
decreases in units of 1 Hz. By pressing and
holding these buons, you can increase or
decrease the value continuously. This set-
ting is stored even when the power is o.
4.
Play a single note on your instrument.
The closest note to the input sound will
appear in the center of the display. Tune
your instrument to the correct pitch, so
that the desired note name appears.
If you’re using the internal mic, place
your instrument as close as possible
to the mic so that extraneous sound is
not picked up while tuning.
5.
While playing a single note on your
instrument, tune your instrument so that
the tip of the meter indicates “
q
” and
the center indicator of the tuning guide
is lit up.
The le tuning guide indicator will light
up if the pitch of your instrument is at,
and the right indicator will light up if the

Korg TM-50 Specifications

General

Brand	Korg
Model	TM-50
Category	Tuner
Language	English