19
Try it out
11
11
1 When you finish making connections, set the
power switch in the “ON” position. (This set-
ting is referred to as Play mode.)
Use the +/– buttons to select a program. Se-
lect a clean-type program that will be suitable
for setting the volume. (As an example here, we
will select Program 1 “M’ M”.)
Program name
Program number
22
22
2 Set the input level switch accordingly to the
output level of your bass.
Input level switch
Hi: High-output basses (active pickups)
Lo: Low-output basses (passive pickups)
33
33
3 Set the volume control of your bass to its
usual settings.
Use the Value dial to adjust the master level.
To Next Page
Loading...
