TRITON STUDIO Easy Start
9
! See the TRITON STUDIO Getting Started Guide, pp. 116-117 for more information.
NEW!! Ripping audio from a CD
Digital data from an audio CD in the CDRW-1 option can be imported as sample data in the digital domain. This
process is known as “ripping”.
1. Insert an audio CD into the CDRW-1
Ä Press the [SAMPLING] mode key Ä In the Input Setup tab, check that the Input
X popup is set to Analog
Ä Set levels to 127 for both Inputs 1 and 2 Ä Set Pan of Input 1 to L000 and Pan of Input 2 to
R127
Ä Set BUS(IFX/Indiv.) to L/R for both Inputs 1 and 2.
2. Press the [MENU] key, then press P.5 Audio CD
Ä Check that Drive is set to CDD: Audio CD (or ID# for external
CDRW)
Ä Select the CD Track X that you want to rip Ä Press the Volume “slider” in the display and use the DIAL to
set CD playback level
Ä P-ress the SEQUENCER [START/STOP] key to begin playback, and press the [ENTER] key to
make markers defining the ripping Range Start and Range End
. Ä P-ress the SEQUENCER [START/STOP] key to stop
playback. Note that the Range Start and End points can be selected and values changed with the DIAL or numeric
keypad. You can then playback, re-entering start to end points to determine the exact range for ripping to occur.
3. Press the upper right ▼ popup and press Destination
Ä Select RAM as the destination if you want to place this digital
data in sample memory
Ä Press OK. Now you can continue to edit the ripped audio sample in Sampling mode.(Note that
selecting DISK sets the ripped audio data destination as the internal hard disk)
Important Owner’s Manual References
Basic Program and Combination editing Basic Guide, pgs. 34 and 35
Copying a Combination to the Sequencer
Basic Guide, pgs. 95-97
Creating and Recording RPPR (Realtime Pattern Play/Record)
Basic Guide, pgs. 93-95
Sampling: Converting a Multisample to a Program
Basic Guide, pg. 112
Sample Looping, Time Slicing and advanced Sample editing
Basic Guide, pgs 104-110; Param Guide, pgs. 107-118
In-Track Sampling
Basic Guide, pg. 115-116
Resampling song playback to create a WAV file
Basic Guide, pg. 116
Creating an Audio CD from WAV files
Basic Guide, pg. 118
Creating a user arpeggio pattern
Basic Guide, pgs. 134-137
Effect Guide
Param Guide, pg. 177
Alternate Modulation
Param Guide, pg. 241
Dynamic Modulation
Param Guide, pg. 246
Routing Individual Outputs
Param Guide, pg. 185
To Previous Page
Loading...
Need help?
General
