X
<Activating Test Node>
Insert
the PCM card
and the RAM card into their
respective slots,
and insert a blank disk for testing into
the
floppy disk drive.
Turn on the power while pressing
both [ENTER] and
[5].
This
activates
the test lode.
When the test node is activated, the
internal tests listed below
are done
autoiatical
ly. If
the results of these
tests are all nornal, the systen
loves on to the
external
test
Item
1,
<Panel SW Test>.
The
internal
test iteis
are as follows^
*
Systei
RON Check Sui
*
Internal
RAM Test
*
Card RAM Test
*
LCD RAN Test
*
TGL I/F Test
*
Internal Battery Test
*
Card Battery Test
'
NIDI Loop Test
*
PCM RON TG I/F Test
*
PCM CARD TG I/F Test
(Internal
TestttOl)
(Internal Test#02)
(Interanl Test#03)
(Internal Test#04)
(Internal Test#05)
(Internal Test#06)
(Internal Test#07)
(Interanl
Test#08)
(Internal
TestifOO)
(Internal TestUlO)
If any of the
internal
tests results in an
error, the details
are
displayed on the LCD.
^
Notes:
-
The fora of
activation of the test
aode depends on
the combination
of keys* pressing
while the
power
is
turned on. They
are as
follows:
[11+EENTER]
[51+EENTER]
[7]
+[ENTER]
[8]
+[£NTER]
To perfora tests
using the test
menu.
To perfora
internal and external
tests.
To display the
System
Version No. only.
To
perfora external
tests only.
Ordinarily, is used.
-
Use the
following keys to
aove back
and forth among the
test steps:
Cursor key []:
Cursor key [^]:
Move
forward
Move
backward
17
To Next Page
Loading...
Need help?
General
