INsTRUCTION
1
3
30 mm
11.5 mm
60 mm
2
432
wh003ba110-B
●Thanks for purchasing our Ambiant Temperature meter. Before operating this unit, please read the instruction carefully and retain them for
future reference.
1.This lcd meter is work on DC 12 volts applications only.
2.For proper installation, please follow the steps described in instruction. Any damage caused by wrong installation shall be imputed to the users.
4.Do not disassemble or change any parts.
5.Opening the instrument will void any warranty. Maintenance or repair should be excecuted by our professionals only.
3.Don't break or modify the wire terminals. To avoid short circuit, do not pull the wires out of the terminal when installing.
Notice
MARK MEANING:
PRESS THE
BUTTON ONCE
PRESS THE
BUTTON 3
SECONDS
CAUTION!
Some procedures must be followed to avoid the damages to the vehicle.
WARNING!
Some procedures must be followed to avoid damages to the instrument.
Some procedures must be followed to avoid injuries to the user or others.
Meter X 1
Mid-way connector X 2
Velcro X 1 set
Temp sensor wire set X 1
Temp sensor wire set 2( )Accessory
Mid-way connector (Accessory 3)
Wiring installation instruction
Red / "+"Wire connect to the DC 12v igniton switch
Meter (Accessory 1)
Please contact your local distributor if the items received are not the same as the one listed above.
Function instruction
Display range -30~120 -22~248 ℃ ( ℉ )：●Thermometer
Display unit:0.1℃ (℉ )
Around 22 g
●Meter weight
-20~+60 C
o
●Eective voltage
DC12V
●Effective temperature range
●Meter standard
●Meter size
JIS D 0203 S2
60 X 30 X 11.5 mm
Design and specifications are subject to change without notice.
Black / Ground wire connect to the vehicle body or
the engine (must be a good ground)
Temperature-Yellow/Green
1-1
Accessory
(-4 ~+140F)
To Next Page
Need help?
General
