Kospel PPH2 - Safety Instructions; General Installation and Operation Safety; Electrical Connection and Safety; Installation Location and Temperature

11
046AB/f.391
Safety instructions
1. Read and strictly follow the installation and operating instructions to ensure a
long life and reliable unit operation.
2. The unit is designed to be wall mounted.
3. The unit can only be used when in perfect technical condition and correctly
installed.
4. If there is a non-return valve installed on the water supply pipe the safety valve
must be tted between the unit and non-return valve.
5. Inlet and outlet pipes should not be made of plastic. This relates to KDH only.
6. The unit should always be vented before initial start-up. Vent the unit each time
after the water has been emptied from the heater or pipes (e.g. when water
supply system has been repaired or maintained).
7. Connection to electrical system and measurement of re protection effectiveness
should be made by a qualied person.
8. The unit has to be earthed or neutrally grounded.
9. The unit must be permanently connected to the electrical system equipped with
an earth clamp.
10. Electric installation should be equipped with residual current protective devices
and other solutions which will ensure disconnecting the heater from the source
of power (intervals between all their poles should not be less than 3 mm).
11. The unit must not be installed in the place which is exposed to the danger of
explosion and place in which the temperature may go down below 0
0
C.
12. It is not recommended to use mixer taps with thermostat.
13. The unit must be kept in a place in which the temperature never goes down
below 0
0
C (there is a water inside the unit).
14. The unit must be connected to the cold water supplies only.
15. Do not use when the water has been emptied from the unit or pipes (e.g. when
water supply system has been repaired or maintained).
16. Unit’s cover must not be taken off while power is on.
17. Failure to install the lter on water supply pipe can cause unit damage.
18. Appropriate precaution must be taken when using hot water. Temperature of
water over 40
0
C may cause hot feeling and can be dangerous for children.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision or
instructions concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
GB