11
If the boundary wire gets cut or breaks
for any reason (indicated by solid red
light on charging station), you need
to locate and repair it. You will need to
use one of the splicing clips provided.
First take up the slack in the wire so
there is some overlap.
Taking a pair of pliers, crimp the metal
tab onto the inserted wires. This will
form a connection between the wires.
The clip has two channels in it. Push
one end into one channel and the
other end into the other. The wire
needs to go right in.
Repairing the boundary wire
When the boundary wire is repaired
the signal indicator light on the
charging pile will light up. If the light
is still out there are more breaks in
the loop, which will need locating
and repairing.
To Next Page
Loading...