7
Please install Boundary Wire the
perimeter in the slot of the bottom
of the charging station.
Install the pegs to fix the station.
Trim the wire head to expose the
metal part.
Insert it into the"F" interface.
Note:Install the charging station on a soft and flat surface. Do not place
the charging station too close to a slope, such as at the top of a hill or the
bottom of a furrow. Avoid left and right inclination in excess of 5 degrees.
01.
04 .
02 .
03.
Installing the charging station
On corners the wire should not be laid at a sharp angle or right angle, but curved
or a series of obtuse angles. It should be noted that due to this set up some areas
of the lawn will not get mowed such as outside the perimeter edges. These can be
maintained using a suitable grass trimmer.If the ground where the wires are to be
laid is particularly dry and the soil hard from lack of rain, it will help to thoroughly
water the garden before attempting to lay your perimeter wire.
To Next Page
Loading...