20
Type Error How to solve
Application
Wire sensor polarity
reversed!
The perimeter wire is set
in the opposite terminal of
the charging station.
Press the “Reset” button. Reset the
perimeter wire.See chapter “Encircling
obstacles” for details.
Reconfirm boundaries?
The perimeter wire is set
wrong which cannot be
detected by the mower.
Press the “Confirm” button. Reset the
perimeter wire.See chapter “Encircling
obstacles” for details.
Unable to leave !
The mower is in trouble to
get through the working
area.
Press the “Reset” button. Check if there are
any bumps or potholes. DO NOT allow the
mower mowing there again before making
them flat.
There are obstacles on
the path !
The mower is in trouble
with some obstacles on
the path.
Press the “Reset” button. Move the obstacles
from the path.
Out !
The mower is not in the
boundaries.
Press the “Reset” button. Stop the mower
and move the mower into the working area ,
r
estart it.
Boundary inspection time
out !
The mower impacting the
obstacles causes the walk
time out during the
recharging procedure.
Press the “Reset” button. Move the obstacles
from the recharging path.
Abnormal power loss !
The battery of the mower
is losing power.
Press the “Reset” button. Recharge the
mower.
To Next Page
Loading...